Impact windows in the Town of Palm Beach, FL must meet the wind-borne debris rules, with a 170 mph coastal design wind speed on the county map. The Town's Planning, Zoning & Building department issues the permit, and ARCOM or Landmarks Preservation review may apply. The island is outside the HVHZ.
Last checked: November 3, 2026 · General guidance. Confirm requirements for your address with the building department that serves Palm Beach.
Palm Beach is the island where design review comes with the windows
Most Palm Beach County cities ask one question about a window job: does it meet the wind code? The Town of Palm Beach asks a second one: does it fit the Town? That is why this page starts with review, not with glass.
The Town has an Architectural Commission (ARCOM) that rules on whether exterior renovations and new construction meet its standards. It also has a Landmarks Preservation Commission (LPC) that reviews exterior changes to landmarked buildings and historic districts. The Town says more than 350 landmarked properties, sites and vistas are protected, and it publishes a Landmark Property List so you can check an address.
The Town's Shutter/Window/Door Permitting Guidelines say that when staff sees inconsistent replacement products, or finds missing Town approvals, ARCOM or LPC review may be needed to decide what products are acceptable. For landmarked properties, the Town's administrative review guide flags that vinyl and fiberglass window and door materials need commission review.
What this means for you: ask the Town before you order. Whether a like-for-like impact window swap needs a board is a question for Town staff, and the answer can depend on your property and the product.
- Check your address against the Town's Landmark Property List.
- Keep the existing frame color, grid pattern and operation in mind when choosing products.
- Ask staff in writing, and keep the answer with your permit file.
Quick facts for window projects in the Town of Palm Beach
These are the numbers and offices that apply to a typical single-family home on the island. Condo buildings add their own association steps.
| Item | What applies |
|---|---|
| Design wind speed | Palm Beach County's 2023 wind map has a 170 mph band along the coast, and the island sits in the coastal zone. Confirm your parcel with the county's GIS wind tool. |
| High-Velocity Hurricane Zone | No. The HVHZ is Miami-Dade and Broward only. |
| Wind-borne debris region | Yes. Glass openings need impact-rated products or approved shutters. |
| Code | Florida Building Code, 8th Edition (2023), with Palm Beach County amendments, in force since Dec. 31, 2023. |
| Permit office | Town of Palm Beach Planning, Zoning & Building, (561) 838-5431. Not Palm Beach County's unincorporated-area system. |
| Design review | ARCOM and the Landmarks Preservation Commission, when the project calls for it. |
| Product approval | Florida Product Approval accepted; Miami-Dade NOA also accepted. |
| Typical inspections | County amendments check window buck attachment and framing; a final closes the permit. Your permit lists the Town's exact schedule. |
The wind side: 170 mph coast, debris region, no HVHZ
The Town of Palm Beach is in Palm Beach County, so it is outside the High-Velocity Hurricane Zone that covers Miami-Dade and Broward. Do not let a Miami-style quote tell you otherwise. HVHZ-only rules do not apply here.
It is still in the wind-borne debris region. The Florida Building Code puts land within one mile of the coast with a design speed of 130 mph or more in that region, and anywhere at 140 mph or more. Every mapped speed in the county is above 140 mph. Glass openings need impact-rated windows and doors or approved opening protection.
The county's map shows a 170 mph band along the coast, with 160 mph further inland. A barrier island is the most exposed ground in the county, so plan on the 170 mph band. Palm Beach County also publishes GIS tools that give the design speed of a single parcel. Use it, and put the result in your file.
Design pressure differs by opening and by location on the house. Ask for the pressure rating of each opening, not just the product name.
Product approval and the permit
Outside the HVHZ, a window or door needs a Florida Product Approval number. A Miami-Dade Notice of Acceptance is also accepted. Palm Beach County also runs a local approval route for products that lack statewide approval. Keep the approval for every opening in the permit file, because inspectors check that what is in the opening matches the paperwork.
Florida requires a permit to replace windows and exterior doors. In the Town of Palm Beach, that permit comes from the Town's Planning, Zoning & Building department, not from the county. The department lists permit forms on its website and takes calls at (561) 838-5431.
Palm Beach County's code amendments list the window buck attachment, window framing, rough-opening size and energy values among the items checked at the framing inspection. If the opening changes size, expect engineering and a window schedule.
For a job above the notice threshold in Florida law, the owner records a Notice of Commencement before the first inspection. Skipping it can leave an owner paying twice for the improvement. Florida's owner-builder exemption covers only a home you will live in, and a sale or lease within a year of finishing creates a presumption the work was for sale or lease.
When a bigger renovation changes the window question
Many island homes are renovated in phases. Palm Beach County's code amendments carry a Florida rule for site-built single-family homes in the wind-borne debris region: when a permitted project reaches certain cost and home-value thresholds, opening protection that meets new-construction requirements must be provided.
If you plan an addition or a full remodel, ask the Town how the rule applies to your permit before you decide what to replace. It can change the scope from some windows to every opening.
Homes, owners and what it means for window styles
Census QuickFacts lists the owner-occupied housing unit rate for the Town of Palm Beach at 82.7 percent for 2019 to 2023. A third-party summary of ACS data puts the median year built at 1971, which points to an older housing stock. Treat that figure as a guide, not a count.
For a window project, the style of the house matters more than the age of the average house. If your home has arched tops, large fixed glass, French doors or divided-lite patterns, bring that up early. Matching those details with impact products can affect product choice and lead time, and a design board may care about them.
Sliding glass doors to patios and pools, and tall entry doors, carry large pressures. Ask about both the glass build and the frame, and about hardware finish near salt air.
Oceanfront: turtle lighting, salt air and flood rules
The Atlantic is on one side of the island and the Lake Worth Lagoon on the other. Both bring salt air, so ask for a finish suited to a marine setting and hardware that will not corrode.
From March 1 through October 31, the Town's Shielding of Light ordinance requires oceanfront owners to turn off lights that shine on the beach or ocean and to shield other lights so they cannot be seen from the shoreline. Palm Beach County's beachfront lighting rules, in force since 1987, also cover glass in the sea turtle protection zone in some towns. Ask the Town whether new glass on your oceanfront lot needs lighting review.
The Town also has a floodplain management ordinance and publishes flood information for owners. If your house is in a mapped flood zone and the work is large, ask whether it counts as substantial improvement.
Condo and co-op buildings
The Town counts 95 condominium or co-op buildings of three stories or more, nearly all 25 years old or older. Florida's milestone inspection law (SB 4-D, section 553.899) applies to them. It requires an inspection when a building reaches 30 years, or 25 years where the local agency decides conditions such as salt water call for it, and every 10 years after.
For a unit owner, windows are usually common elements or association-controlled. Boards often set one approved product, color and installation method for the whole building. Get written association approval first, then apply for the permit.
What storms have done here
The 1928 Okeechobee hurricane came ashore between Jupiter and Boca Raton as a Category 4. The National Weather Service describes a storm surge of about 10 feet with waves up to about 20 feet on the barrier islands, including Palm Beach.
In September 2004, Frances and Jeanne crossed the county about three weeks apart on nearly the same track, and Jeanne hit buildings already weakened. In October 2005, the eye of Wilma covered all of Palm Beach County, and Palm Beach International recorded a 101 mph gust. These are county records, and they show why the code treats this coast as a debris region.
A wind mitigation inspection (Florida form OIR-B1-1802) can document opening protection for insurers.
Working with Vieser Construction
Vieser Construction is an authorized installer for ESW, Mr. Glass and PGT. We work from Fort Lauderdale across Broward, Miami-Dade and Palm Beach counties.
Permit assistance is available. Our team coordinates the complete permitting process, including required documentation, engineering and permit submission, when applicable.
We coordinate your complete installation from measurement to final inspection. Materials typically arrive 2–3 weeks after contract for in-stock projects.
If your home is landmarked or in a design-reviewed area, tell us at the first call. We will ask for your address, the opening sizes and any photos. To see current factory pricing by size, use the instant price tool on Windows Stock Market.
Impact windows in Palm Beach: questions we hear
Do impact windows in the Town of Palm Beach need a permit?
Yes. Florida requires a permit to replace windows and exterior doors. In the Town of Palm Beach the permit comes from the Town's Planning, Zoning & Building department at (561) 838-5431, not Palm Beach County's unincorporated-area system. The permit file should hold the product approval for each opening.
Do I need ARCOM or Landmarks Preservation approval to replace windows?
It depends. The Town's guidelines say ARCOM or Landmarks Preservation Commission review may be needed when product replacements are inconsistent or Town approvals are missing. For landmarked properties, vinyl and fiberglass window and door materials need commission review. Check your address against the Town's Landmark Property List and ask staff.
What wind speed applies to my Palm Beach home?
Palm Beach County's 2023 wind map has a 170 mph band along the coast, and the island is coastal. The county publishes a GIS tool for the design speed of a specific parcel, so confirm your address there. The town is outside the HVHZ but inside the wind-borne debris region.
Does Palm Beach accept Miami-Dade NOA or Florida Product Approval?
Outside the HVHZ, Florida Product Approval is accepted, and a Miami-Dade Notice of Acceptance is also accepted. Palm Beach County has a local approval route for products without statewide approval. Whichever you use, keep the approval document for every opening in the permit file for inspection.
Do condo owners on Palm Beach island need association approval first?
Yes, check with your association first. Windows in a condo building are usually controlled by the board, which often sets one product, color and method. Florida's milestone inspection law applies to condo buildings of three stories or more, and the Town counts 95 of them. Ask your manager what the board has approved.
Does sea turtle lighting affect new windows on an oceanfront lot?
Possibly. From March 1 through October 31 the Town requires oceanfront owners to shield lights from the beach, and county rules in some towns require approval for new glass in the sea turtle protection zone. Ask the Town whether your lot needs review before you order glass.
Related
- See current factory pricing by window size (ESW, Mr. Glass)
- Impact windows and doors: material price guide
- How to replace windows in Palm Beach County, step by step (West Palm Beach guide)
- Impact doors
Planning impact windows in Palm Beach? We coordinate your complete installation from measurement to final inspection.
Call (754) 707-3281 or request an estimate.
Sources: Palm Beach County PZB – Wind Speed Maps · Palm Beach County Amendments to the Florida Building Code, 8th Edition (2023) · Florida Building Commission – HVHZ definition · Town of Palm Beach – Shutter/Window/Door Permitting Guidelines · Town of Palm Beach – Administrative Review Guide · Town of Palm Beach – Landmark Property List · Palm Beach County – Product Approval · Palm Beach County ERM – Beachfront Lighting · Town of Palm Beach – 2019 Annual Flood Report · U.S. Census Bureau QuickFacts – Palm Beach town · Florida Statutes s. 553.899 · Florida Statutes s. 713.135 · Florida Statutes s. 489.103 · NWS Miami – 1928 Okeechobee Hurricane · NWS Miami – Hurricane Frances · NWS Miami – Hurricane Jeanne · NWS Miami – Hurricane Wilma
Other Palm Beach County cities we serve
Impact windows across Palm Beach County
- Impact windows in Tequesta
- Impact windows in Jupiter
- Impact windows in Juno Beach
- Impact windows in North Palm Beach
- Impact windows in Palm Beach Gardens
- Impact windows in Lake Park
- Impact windows in Riviera Beach
- Impact windows in Royal Palm Beach
- Impact windows in Westlake
- Impact windows in Loxahatchee & The Acreage
- Impact windows in Wellington
- Impact windows in Greenacres
- Impact windows in Palm Springs
- Impact windows in Lake Worth Beach
- Impact windows in Lantana
- Impact windows in Hypoluxo
- Impact windows in Boynton Beach
- Impact windows in Ocean Ridge
- Impact windows in Highland Beach