Skip to main content

Vieser Construction

Vieser Construction · Material price online

See your price at your exact size →

Material price in seconds, no sales visit. Installation is quoted separately. Prefer a visit? Request a free estimate or call (754) 707-3281.

See prices by size →

Impact windows in Juno Beach, FL must meet the wind-borne debris rules of the Florida Building Code, with a coastal 170 mph design wind speed on the county map. The Town of Juno Beach Building Department issues permits through MGO Connect. Beachside glass also needs sea turtle compliant tint. Vieser Construction installs ESW, Mr. Glass and PGT.

Last checked: November 3, 2026 · General guidance. Confirm requirements for your address with the building department that serves Juno Beach.

Beachside glass has a turtle rule most Palm Beach County cities do not have

Juno Beach sits on one of the busiest sea turtle nesting beaches in Florida. Loggerhead Marinelife Center reported a record 25,025 nests on its 9.5-mile stretch of beach in 2023. Turtles nest on Palm Beach County beaches from March through October, and the Town protects them with lighting rules that reach into your window choice.

The Town runs a separate Sea Turtle Lighting Permit Application for windows and glass doors. It says new glass doors and windows inside the Sea Turtle Protection Zone need approval. The Town's form also says tinted glass must be installed on all new windows and doors within line of sight of the beach.

The numbers on that form are specific. Tinted glass must have a visible light transmittance (VLT) of 45 percent or less, and it needs a minimum five-year warranty. The Town's code adopts the Palm Beach County sea turtle ordinance by reference, so the county rule and the Town rule travel together.

State wildlife guidance goes further than the Town. Florida Fish and Wildlife guidance points to 15 percent transmittance as the most protective option for turtles, with 25 to 30 percent the most popular. That is guidance, not the Juno Beach requirement, but it is a useful target if your windows face the sand.

  • Facing the beach or the dunes? Ask for the tint and VLT on the product data sheet before you order.
  • Planning a sliding glass door onto a balcony? It counts as a glass door under the Town form.
  • Unsure about the protection zone? Call the Town at (561) 626-1122 first.

Juno Beach window projects at a glance

These are the facts that decide what you can install and who signs off. Confirm your address with the Town before you order, since parcels near a map line can differ.

Quick facts for Juno Beach window projects
Item What applies in Juno Beach
Wind zone Outside the HVHZ (Miami-Dade and Broward only); inside the wind-borne debris region
Design wind speed (Risk Category II) Coastal 170 mph band on the Palm Beach County map; check your parcel on the county GIS tool
Code Florida Building Code, 8th Edition (2023), in force since December 31, 2023
Permit authority Town of Juno Beach Building Department, Town Center, 340 Ocean Drive
Online system MGO Connect (digital submittals and inspection scheduling)
Phone and email (561) 626-1122, permitting@juno-beach.fl.us
Product approval Florida Product Approval or Miami-Dade NOA
Beachside glass Sea turtle lighting approval; tint of 45 percent VLT or less, five-year warranty
Appearance review Window and door color and styling are listed as building design elements in Town code
ZIP code 33408

Wind speed and code: coastal, but not the HVHZ

The Florida Building Code puts only Miami-Dade and Broward Counties in the High-Velocity Hurricane Zone. Juno Beach is in Palm Beach County, so HVHZ testing rules do not apply. The county's own wind page says all of unincorporated Palm Beach County is a wind-borne debris region. Juno Beach is a town, but its wind speeds are well above the 140 mph line that triggers debris protection, so glass openings need impact-rated products or approved shutters.

Palm Beach County's Risk Category II map uses a 160 mph band inland and a 170 mph band along the coast. Juno Beach is on the coast, so the 170 mph band is the one to expect. These are ultimate 3-second gust speeds at 33 feet in open terrain. Use the county parcel lookup to check your lot.

The wind speed becomes the pressure your windows must resist. A product approval has to cover your opening size at that pressure, not just the product line in general. Both Florida Product Approval and Miami-Dade NOA are accepted in Palm Beach County.

Permits: the Town runs its own Building Department

Florida requires a permit to replace windows and exterior doors. In Juno Beach that permit comes from the Town of Juno Beach Building Department at the Town Center, 340 Ocean Drive. It is a Town office, not a Palm Beach County counter.

Since October 1, 2023 the Town has taken digital submittals through MGO Connect. Inspections are also scheduled online there, and card payments are accepted in the portal. The Town Center takes cash and checks only.

The Town accepts only its own permit application form. Its FAQ says contractors must register with the Town before applying, and submittals include the contractor's license and certificates of insurance naming the Town as certificate holder. Palm Beach County Fire Department review fees are billed separately and must be paid before the permit is issued.

A fee schedule exists, and the Town last amended its fee booklet on January 28, 2026.

  • Beachside projects may need the separate sea turtle lighting approval.
  • Appearance review can apply if you change the color or styling of windows and doors.
  • Your HOA or condo board approval is separate from the Town permit.

A condo-heavy town changes the window job

Juno Beach has about 3,660 housing units and roughly 3,900 residents. Around two-thirds of occupied homes are owner-occupied. Public ACS summaries put the median year built around 1990, and they show only about one home in nine as a detached single-family house. Most of the town is condos, townhomes and other attached buildings.

The Town's own timeline says condominium construction along Ocean Drive began in the 1970s. Today the oceanfront has towers such as Juno by the Sea, Waterfront on the Ocean, Ocean Royale and Oceanfront at Juno Beach. Behind them are townhome and single-family pockets such as Seaview, Juno Dunes and Ocean Ridge.

For you, that means two things. First, many jobs are sliding glass doors, large fixed panes and balcony openings, where size and wind pressure matter most. Second, the buyer is often an owner who needs the association to say yes before the Town does.

  • Sliding glass doors and fixed picture windows face the highest pressure on tall oceanfront buildings.
  • Most associations set a standard frame color, glass tint and product spec for the whole building.

Condo boards, HOAs and the milestone inspection rule

Florida law limits what a condo board can do. Under section 718.113, if your documents require board approval, the board may not refuse to approve installing or replacing impact glass or code-compliant windows. The board can still set specifications, such as frame color and tint, so get them in writing first.

Condo and co-op buildings three stories or taller also fall under Florida's milestone inspection law (section 553.899, from SB 4-D). The first inspection is due by December 31 of the year the building turns 30, or earlier where the local agency sets 25 years, such as near salt water. Repeat inspections follow every 10 years.

The Town also lists the color and the location or styling of windows and doors among its building design elements in the code. A 2025 staff packet said single-family homes outside a planned development were subject to appearance review, and the council later signaled it wanted to drop that review. We could not confirm which change took effect. Ask Planning and Zoning before you change a frame color.

Barrier island exposure: surge, salt air and flood zones

The Town describes itself as a barrier island, with the Atlantic on one side and the Intracoastal Waterway on the other. Its flood page warns that some areas are prone to flooding and that a normal homeowners policy does not cover it. The FEMA map panel for the town shows Zone VE, the coastal high-hazard zone with wave action, along the coast and Zone AE elsewhere.

Beachfront openings take wind, wave-driven water and sand. Salt air also wears on frames, so ask about finish and hardware when you compare products.

After the 2014 draft FEMA maps, the Town hired its own engineer, and a 2017 report said the number of buildings in high-risk flood zones dropped to about 600.

What storms have done here

Juno Beach has seen real storm damage. A Palm Beach County year-in-review reported that Hurricane Frances in 2004 caused damage across town, worst at a two-story oceanside residential complex on Mercury Road. Hurricane Jeanne followed three weeks later and did only minor damage locally.

In November 2022, Hurricane Nicole made landfall near Vero Beach as a Category 1. The highest gust recorded in Palm Beach County was 62 mph at the Juno Beach Pier, and king tides added flooding and beach erosion. In January 2017 an EF-1 tornado that tracked from Palm Beach Gardens to Juno Beach pulled railing panels off the pier.

Working with Vieser Construction

Vieser Construction is an authorized installer for ESW, Mr. Glass and PGT. We are based in Fort Lauderdale and work across Broward, Miami-Dade and Palm Beach counties. For a Juno Beach project, here is what the process looks like.

Permit assistance is available. Our team coordinates the complete permitting process, including required documentation, engineering and permit submission, when applicable.

We coordinate your complete installation from measurement to final inspection. Materials typically arrive 2–3 weeks after contract for in-stock projects. For a first look at cost, see current factory pricing by size on the instant price tool.

If you live beachside or in a condo, send us your association's window rules and your address up front. That lets us match tint, frame color and product approval to the Town and the board before you order.

  1. Measure and choose. Opening sizes and wind pressure set which approved product fits each window and door.
  2. Check the rules. Wind speed, sea turtle tint, appearance review and your association's specs are confirmed before ordering.
  3. Permit and install. The permit goes through the Town's MGO Connect portal, and the work ends with the Town's final inspection.

Juno Beach neighborhoods we serve

Juno by the SeaWaterfront on the OceanOcean RoyaleOceanfront at Juno BeachSeaviewJuno DunesOcean RidgeSurfside HillsSea OatsThe Preserve

ZIP codes: 33408

Impact windows in Juno Beach: questions we hear

Do I need a permit to replace windows in Juno Beach?

Yes. Florida requires a permit to replace windows and exterior doors. In Juno Beach the permit comes from the Town of Juno Beach Building Department at 340 Ocean Drive. Applications go through MGO Connect, and you can call (561) 626-1122 to confirm what your specific project needs before you start.

Does Juno Beach use the Palm Beach County building department?

No. Juno Beach has its own Building Department at the Town Center. It takes digital submittals and schedules inspections through MGO Connect. County rules still apply in places: the county wind map sets your design wind speed, and the county sea turtle ordinance is adopted into Town code. County fire review fees are billed separately.

What wind speed and product approval apply in Juno Beach?

Juno Beach is outside the HVHZ but inside the wind-borne debris region. Palm Beach County's Risk Category II map uses 170 mph along the coast, and the county has a parcel lookup for your lot. Florida Product Approval and Miami-Dade NOA are both accepted, as long as the approval covers your opening size and pressure.

Do sea turtle rules affect my window tint in Juno Beach?

They can. The Town says new windows and doors within line of sight of the beach need tinted glass with a visible light transmittance of 45 percent or less and a minimum five-year warranty. New glass in the Sea Turtle Protection Zone needs approval. Call the Town to confirm whether your address is covered.

Does my condo board or HOA have to approve impact windows?

If your documents require approval, Florida's condo law says the board may not refuse to approve impact glass or code-compliant windows. It can still set specifications such as frame color and tint. Get the association's written spec first, because the Town permit and the association approval are separate steps.

Can Vieser help with the Juno Beach permit?

Yes. Permit coordination is available for qualifying projects. Our team manages the required documentation, engineering coordination and submission process from start to finish. Call (754) 707-3281 to ask whether your Juno Beach project qualifies, and have your address and your association's window rules ready.

Related

Planning impact windows in Juno Beach? We coordinate your complete installation from measurement to final inspection.

Call (754) 707-3281 or request an estimate.

Sources: Town of Juno Beach Building Department · Town of Juno Beach Building FAQ · Town of Juno Beach Sea Turtle Lighting Permit Application (windows and doors) · Town of Juno Beach Flood Hazard Information · Town of Juno Beach Historical Timeline · Palm Beach County Wind Speed Maps · Palm Beach County Beachfront Lighting · Palm Beach County Mandatory Milestone Inspections · Florida Statutes 553.899 Milestone inspections · Florida Statutes 718.113 · FWC sea turtle lighting guidelines · WPTV Hurricane Nicole by the numbers




📞 Call Now
Free EstimateCall or Text
See your home with impact windows